There are a couple of different ways that you can go about installing carpet stair tread. These two techniques are called the waterfall method and the cap and band technique. With the waterfall system one long pieces of carpet is used to cover every riser and tread. With a cap and band methodology one piece of carpet is installed over the tread called the cap and another piece, called the band, is used to cover the riser. The waterfall technique is the most well liked method used for installing carpet step tread.
When installing carpet stair tread you will need some basic tools including tack strips, staples, knee kicker, step tool, hammer, safety glasses, use knife, and measuring tape. Your primary step will be to get rid of any old carpet that might be covering the stairs. The old tack strips and padding should also be removed.
Prior to beginning you will need to ascertain how much carpet you will need . If you measure each tread and riser then add around 3 inches per stair. Then multiply that number by the quantity of steps that you have. If your steps have nosing you will have to add around one foot to your total.
Now you are prepared to install. Place a tack strip on the step crotch. Tuck the carpet into the crotch with your knee kicker. The knee kicker will be used to stretch the carpet from the middle of the tread and hook it into the tack strip. Once it is forcefully hooked in you can attach it gently using your carpet tool to compact the tack strip pins. Trim excess pieces using your use knife. Make sure the carpet is smooth before continuing to the next tread. Don’t forget to staple the carpet to the stair lip and tread each couple of inches. Continue this process till all the stairs are covered. Find carpet stair treads here.